Articles:

Make sure you place the screws in a safe place, as you’ll need them later.. Once each of the screws has been removed, the V10 battery should slide out of the bottom of the vacuum’s handle.

Remove the wand, then visually inspect it for blockages.. Next, take a look at the hose to see if there are any blockages.If you can remove the hose, then you could also try (gently) pushing the end of a broomstick through to see if there are any clogs deeper in the hose..

If you don’t want to remove the hose, then you can visually expand it section by section while looking for darker clogs inside or breaks in the hose..Step 5: Wash Both the Filters.The Dyson Ball series typically has two washable filters.

It’s important to make sure these are both unclogged, otherwise the amount of air flowing through the vacuum is greatly reduced..The first filter is located at the top of the cyclones.

You can remove it by detaching the dust canister, then pressing a latch to access the tubular filter.

Rinse it in cold water until it runs clear, squeeze out excess liquid, then allow it to fully dry..Can You Vacuum Your Dog?.

No, you should not vacuum your dog.The loud noise and strange sensation will be highly stressful for your dog, especially as many dogs are already afraid of vacuum cleaners..

Furthermore, the strong suction may cause damage to your dog’s fur and may even lead to injury.If you need to groom your dog, make sure to use a tool that’s specifically designed to be safe for dog fur.. How Can I Get Rid of Pet Hair From Blankets?.